Roland monoFab SRM-20 User Manual page 118

Message
The spindle rotation is stopped.
- The spindle motor experienced an overcurrent.
- The spindle motor experienced an excessive load or it is not
mounted.
The SRM-20 has performed an emergency stop.
- The X-Motor experienced an overload.
- The Y-Motor experienced an overload.
- The Z-Motor experienced an overload.
"File name"
was not found.
Responding
Turn off power of the machine.
The cutting may have exceeded the capacity of the
machine. Before restarting, revise the cutting conditions.
It is likely that it is time to replace the spindle unit or spindle
motor, so check these parts.
Turn off power of the machine.
The cutting may have exceeded the capacity of the
machine. Before restarting, revise the cutting conditions.
If cutting waste has built up and an excess load is being
applied to the axis, please clean up the cutting waste.
Delete the file that produced the error and select the file
again.
118
Responding to Error Messages
Page
""The Spindle Doesn't Rotate
/ Spindle Rotation Speed Is
Wrong" (p. 102)
""Replacement of the
Consumable Parts" (p. 96)
"Cleaning the X-/Z-Shafts"
"
(p. 17)
""Cut Dialog"
(p. 93)