Operations Are Ignored - Roland monoFab SRM-20 User Manual

Operations Are Ignored

Is the Cable Connected?
Check whether the connector cable has come loose. Please use the included
cable.
Was the Machine Started According to the Correct Procedure?
Before you start VPanel, switch on the power to the machine.
(p. 11)
""Start VPanel"
Is a Front Cover Open?
This machine restricts some operations when a front cover is open. Close
the front cover.
Is a Front Guard Pull Down ?
When the front guard falls down, the front cover can not be closed firmly.
Therefore the machine is not performed.
"Part Names and Functions"
"
Is Anything Caught on the Spindle Head or Rotary Axis Unit?
Check whether something has become caught and is impeding initialization.
(p. 9)
Is a Large Amount of Cutting Waste Present?
Clean away any cutting waste. Clean the area around the spindle head
especially carefully.
""Cleaning after Cutting Operation Ends"
Is Operation Paused?
When the machine is paused, cutting stops and some operations are
restricted. When you press the
canceled.
(p. 76)
""Pausing / Resuming"
Is the Driver Installed Correctly?
If the connection to the computer is not made in the sequence described,
the driver may fail to be installed correctly. VPanel does not function
normally when driver is misconfigured. Check again to ensure that the
connection was made using the correct procedure.
"http://startup.rolanddg.com"
"Download
""The Driver Cannot Be Installed"
Is VPanel Displaying an Error Message?
""Responding to Error Messages"
101
What to Do If...
(p. 93)
"RESUME"
button of VPanel, the pause is
(p. 105)
(p. 117)