Responding To Error Messages; Massage Is Displayed - Roland monoFab SRM-20 User Manual

Responding to Error Messages

Massage is Displayed

Message
No modeling machine was found.
If the power is off, then switch it on.
If the cable is unconnected, then connect it.
The modeling machine is not responding.
Make sure that the connection cable is connected securely and the
machine is switched on.
The SRM-20 has performed an emergency stop.
- X-Limit switch not found.
- Y-Limit switch not found.
- Z-Limit switch not found.
- The NVRAM could not be accessed.
The SRM-20 is paused.
- Cover opened during operation.
The SRM-20 is paused.
- Command Error
Responding
Check connection of a USB cable.
After you take actions such as turning on the power and
connecting the cable, press [Retry].
Check connection of a USB cable.
After you take actions such as turning on the power and
connecting the cable, press [Retry].
'
Switch the machine s power off, then back on again.
If the symptom persists, a malfunction may have occurred.
Switch off the machine's power and contact your authorized
Roland DG Corp. dealer where you purchase the machine.
Operation cannot be continued.
In order to resume cutting, please close a front cover and
click [RESUME].
Click [STOP], when you stop cutting.
You can ignore this and continue with cutting, but doing
so is very likely to result in unintended operation, so we
strongly recommend you stop cutting.
If command does not match the machine's command set,
select correct command set.
117
Page
(p. 11)
""Start VPanel"
""VPanel Does Not Recognize
the Machine" (p. 100)
"Operations Are Ignored"
"
101)
(p. 76)
""Pausing / Resuming"
(p. 77)
""Cancel the Cutting"
""STEP 3 : Confirm the Command
Set" (p. 65)
(p. 77)
""Cancel the Cutting"
(p.