Items Related To The Mechanical Specifications - Roland monoFab SRM-20 User Manual

Tool-Diameter Offset Value
[Setup]
On the VPanel, click
coordinate system.
Tool-Diameter Offset Type (G41, G42)
Select type A or type B. On the VPanel, click
Optional Block Skip (/)
Enable or disable the optional block skip feature. On the VPanel, click

Items Related to the Mechanical Specifications

This section describes the NC codes that are dependent on the machine's mechanical specifications.
"Separate volume "NC Code Reference Manual"
Dimension Word
Of the four dimension words - X, Y, Z, and A - only X, Y, and Z are supported.
Data Settings (G10)
The ranges of the G10 parameters are as follows.
Parameter : Number
Function : Compensation number
Acceptable range : 1 to 8
Valid range : 1 to 8
Parameter : Radius
Function : Tool-diameter offset value
Acceptable range : Range 1
Valid range : 0 to 10 mm (0 to 0.3937 inches)
and then [NC Code setting]. Then set this value on the
[Setup] and then [NC Code setting]. Then set this value on the
[Tool-diameter Offset]
[Operation Settings] and then [NC Code setting]. Then set this value on the
86
tab. You can also use NC programs to set the G10
[NC Code]
tab.
NC Code Specifications
[NC Code] tab.