Roland monoFab SRM-20 User Manual page 14

No. Name Function
Moves the spindle head to the center and moves the table to
the very front. This position is called [View position].
Use this button when you want to change the cutting tool or
the cutting material.
View
CAUTION
7 Move
Moves the cutting tool to the XY origin point.
X Y / Z
Moves the cutting tool to the Z origin point.
Stop Stops the cutting tool at that point when it is moving.
Selects the coordinate system for setting the base point.
8 Set Origin Point
""STEP 2 : Set the Origin Point"
Sets the current XY position to the base point.
9 X/Y / Z
Sets the current Z position to the base point.
The feeding speed of a cutting tool is adjusted.
10 Adjust
""Adjusting the Feed Rate and Spindle Speed
Under no circumstances move the spindle
unit or table with your hands.
Doing so may cause a breakdown.
(p. 71)
During Cutting" (p. 78)
No. Name Function
Adjusts the spindle speed.
"Adjusting the Feed Rate and Spindle Speed During
Cutting"
11 Spindle Speed
*
The spindle speed cannot be specified from any
application other than VPanel.
Sets the cutting machine's operating conditions and the
correction values for the axes.
Set up
""Setup Dialog"
Configures cutting settings.
Cut
12
""Cut Dialog"
Pauses and resumes cutting.
Pause
""Cancel the Cutting"
Cancel Cancels cutting.
14
VPanel (Operation Panel)
(p. 78)
(p. 15)
(p. 17)
(p. 77)