Test Cut Dialog In Nc Code - Roland monoFab SRM-20 User Manual

Test Cut Dialog in NC Code

If a cutting data file is written in NC code, you can test the output of the file to check for the presence of mistakes (bugs).
(p. 17)
""Cut Dialog"
No. Display
File
Change Coordinate-
system view
Cutting Speed
Quit Cutting
Close
1
2
Function
The files whose output you want to test are
displayed here.
Select the coordinate system that is used to display
the coordinates in the VPanel's main window.
You can adjust the feed rate of the cutting tool.
"Adjusting the Feed Rate and Spindle
"
Speed During Cutting" (p. 78)
Setting unit : 10%
Setting range : 10% to 200%
Click this button during cutting to stop cutting.
Close this dialog.
5
3 6
4
No. Display Function
The code of the file whose output you want to test is
displayed here.
Click this button to generate test output one block at a time.
When you click this button, the next block is executed.
Click this button to pause the test output. When you click this
button while test output is paused, output begins again.
Click this button to execute output as indicated by the program.
Click this button to execute test output at the maximum
cutting tool feed rate. All operations other than the cutting
tool feed rate are executed according to the program.
84
Test output conditions
•
When the current command set is
When the selected file is
• "NC code. "
NC Code Setting
"NC code."