Important Notes On Handling And Use - Roland monoFab SRM-20 User Manual

Important Notes on Handling and Use

Important Notes on Handling and Use

To ensure the full performance of this machine, be sure to observe the following important points. Failure to observe these may not only result in loss of
performance, but may also cause malfunction or breakdown.
This machine is a precision device.
•
Handle carefully, and never subject the machine to impact or excessive force.
• Diligently keep clean of cutting waste.
•
Use within the range of specifications.
• Never attempt to move the spindle head and table by hand with undue force.
•
Never needlessly touch anywhere inside the machine except for locations specified in this manual.
Install in a suitable location.
"http://startup.rolanddg.com"
"Roland DG Start-up
This machine becomes hot.
•
Never cover the ventilation holes with cloth, tape, or anything else.
• Install in a well-ventilated location.
About Cutting tools
•
Use a cutting tool that is suitable for the material and the cutting method.
• The tip of the cutting tool is breakable. Handle with care, being careful not to drop it.
Never allow children to use this machine by themselves and keep it out of children's reach
•
Never keep the machine within children's reach to prevent them from inadvertently swallowing a small part, etc.
• Restrain children from playing with the plastic bag used for packing. Pulling the plastic bag over one's head or swallowing it may lead to suffocation.
Roland DG Corp. has licensed the MMP technology from the TPL Group.Part Names
6