Roland monoFab SRM-20 User Manual page 72

3.
Check that XYZ is "0.00mm."
4.
Select[User Coordinate System], check that XYZ is
"0.00 mm" does not appear for X, Y and Z, click [X/Y], then
If
origin point.
2. Set the origin point
1.
Click
put the mark by STEP1.
""Direction of Y axis using keypad"
"0.00mm."
[Z]
under set
72
[X][Y]
cursor button, move right above the origin point which
(p. 15)
Cutting (One Side Cutting)