Roland monoFab SRM-20 User Manual page 109

3.
Push [ ] ( Power ) button.
Turn off the power of the machine.
WARNING Perform this task with all power switches left
switched off.
Otherwise sudden movement of the machine may
cause injury.
4.
Apply the grease to the shaft of X, Z.
Refer to the figure below, apply the grease to the shaft of each axis.
NOTE: When you apply the grease
If grease is applied superfluously, cutting waste will adhere and it will
become a cause of malfunction.
2. Run in the machine.
1.
Run in the machine.
""STEP 2 : The Machine Run-in"
2.
Excessive grease is wiped off.
If initial operation is completed, wipe off the excessive grease which
accumulated on the shaft.
3. Check the state of motor load .
1.
Click at the upper left of a screen, and click [ Maintenance].
109
What to Do If...
(p. 63)