Actual Size That Can Be Cut - Roland monoFab SRM-20 User Manual

Z Direction
Spindle head bottom
Work plate surface
* A material thicker than this cannot be set.
* The area that the material can be mounted on will vary due to the length of the attached cutting
tool and the thickness of the scrap board.

Actual Size That Can Be Cut

Creating an object of the size of the full axis travel is not necessarily possible. Because a certain amount of clearance in the X-, Y-, and Z-axes directions is required
for no-load feed of the tool, the allowable size of the workpiece is reduced by a corresponding amount. Also, the possible cutting-in depth is generally determined
by the length of the tool. Using a lengthy tool to achieve deep cutting reduces the clearance in the Z-axis direction, which further reduces the allowable size of the
workpiece. The size of what you can cut varies according to the shape of the object you want to create and the tool you use. Give careful thought to this ahead of
time, before you start work.
71 mm *
26
Cutting Area