Table of Contents
Advertisement
4-3 Entering Adjustment Values Yourself
Fine-tuning the Results of Automatic Measurement of Tool Length
When necessary, you can fine-tune the adjustment
values obtained by automatic measurement of tool
length. The [Length Offset] dialog box is updated
with the results of automatic measurement, so you
change the values here.
☞ P. 59, "4-2 Automatic Measurement of Tool Length"
A tool that is longer than the adjustment value per-
forms cutting-in that is deeper than intended. In such
cases, increase the value. Conversely, if the cutting-in
depth is too shallow, reduce the value.
63
Chapter 4 Tool-length Offset
Advertisement
Table of Contents
