Setup Dialog - Roland monoFab SRM-20 User Manual

Setup Dialog

This dialog is displayed when
Modeling Machine Tab
Display
Command Set
Power Option
Unit
Direction of Y axis using
keypad
setup is clicked.
Function
Select the appropriate command mode to match the software to be used.
• [RML-1]
: Select this command set when you want to use the software that was included with this machine
• [NC Code] : Select this command set when you want to use NC codes
""NC Code Specifications"
• [RML-1/NC Code]
: Select this option to enable the machine to receive cutting programs that use the RML-1 or NC code command sets
""STEP 3 : Confirm the Command Set"
Initial setting : "RML-1"
The machine's power can be automatically turned off. The machine can be set to turn off after 0.5 to 24 hours. Initial setting :
The display of the unit of a coordinate system can be chosen. ( For the inches display, the millimeters value is converted and displayed.)
"Millimeters"
Initial setting :
The movement direction when the Y-axis feed button is pressed can be set. Under the factory default settings, Y-axis movement assumes a
direction of cutting tool movement relative to the object being cut. This means that clicking a Y-axis feed button makes the table move in
the opposite direction from what the arrow indicates.
"Move cutting tool to desired location"
Initial setting :
(p. 85)
(p. 65)
15
VPanel (Operation Panel)
"0.5hours"