Platform Level Sensor - Genie S-105 Service Manual

June 2011
REV B
4 Hold the platform rotate left button until the
platform is fully rotated. Continue holding the
button until air stops coming out of the bleed
valve. Close the bleed valve.
Crushing hazard. Keep clear of the
platform during rotation.
5 Connect the clear hose to the bottom bleed
valve and slowly open the valve. Do not remove
the bleed valve.
6 Hold the platform rotate right button until the
platform is fully rotated. Continue holding the
button until air stops coming out of the bleed
valve. Close the bleed valve.
Crushing hazard. Keep clear of the
platform during rotation.
7 Remove the hose from the bleed valve and
clean up any hydraulic oil that may have spilled.
8 Rotate the platform full right then left and
inspect the bleed valves for leaks.
9 Clean up any oil that may have spilled during
this procedure.
S-100, S-120, S-105 (after serial number 250) and
S-125 models (after serial number 998):
1. Rotate the platform full right, then full left until air
is completely out of the rotator. Bleeding the
valve is not necessary.
Part No. 102916
2-4

Platform Level Sensor

The platform level sensor is mounted to the side of
the platform rotator. The platform level sensor is
monitored by the control system to maintain a level
platform throughout boom range of motion. If a
platform level sensor is replaced, it must be
calibrated prior to machine operation.
How to Calibrate the
Platform Level Sensor
Note: Perform this procedure with the machine on a
firm, level surface and in the stowed position.
1 Secure a digital level to one of the side railings
of the platform.
2 Start the machine and level the platform to
gravity. Push the red Emergency stop button in
to stop the engine.
2 Press and hold the enter button
ground control panel while pulling out the red
Emergency Stop button.
3 Press the plus button
button
button
4 Press the enter button
P
LATFORM
LCD screen.
5 Press the plus button
6 Press the enter button
memory.
7 Push one of the LCD
screen buttons shown
until
MV PER DEGREE
S-100 • S-105 • S-120 • S-125
Section 4 • Repair Procedures
PLATFORM COMPONENTS
, then press the enter
twice before again pressing the plus
.
three timees until
L G is displayed on the
EVEL TO RAVITY
once.
to save the setting in
PLATFORM LEVEL SENSOR
is displayed.
on the
4 - 21