Table of Contents
Advertisement
JR
RIGHT MOUNT
REMOVAL
(1) Remove coolant recovery container (Refer to 7 -
COOLING/ENGINE/COOLANT RECOVERY CON-
TAINER - REMOVAL).
(2) Remove heater tube front attaching screw.
(3) Raise vehicle on a hoist and remove inner
splash shield.
(4) Remove heater tube rear attaching screw.
(5) Remove the right engine support assembly ver-
tical fasteners from frame rail (Fig. 74).
(6) Lower vehicle. Remove the load on the engine
motor mounts by carefully supporting the engine
assembly with floor jack and wooden block on oil
pan.
(7) Remove the bolts attaching the engine support
assembly to the engine bracket (Fig. 74).
(8) Remove right engine mount.
Fig. 74 Engine Mounting—Right Side
1 - ENGINE SUPPORT BRACKET
2 - FRAME RAIL
3 - RIGHT ENGINE MOUNT
INSTALLATION
(1) Position right engine mount and install frame
rail to mount bolts. Tighten bolts to 61 N·m (45 ft.
lbs.) (Fig. 74).
(2) Install the mount to engine support bracket
bolts and tighten to 61 N·m (45 ft. lbs.) (Fig. 74).
(3) Raise vehicle on a hoist.
(4) Install heater tube rear attaching screw.
(5) Install inner splash shield and lower vehicle.
(6) Install heater tube front attaching screw.
(7) Install coolant recovery container (Refer to 7 -
COOLING/ENGINE/COOLANT RECOVERY CON-
TAINER - INSTALLATION).
ENGINE 2.4L DOHC
FRONT MOUNT
REMOVAL
(1) Raise vehicle.
(2) Remove front mount to bracket horizontal
through bolt (Fig. 75).
(3) Remove front mount vertical bolts (Fig. 75).
(4) Remove front mount.
Fig. 75 FRONT ENGINE MOUNT
1 - HORIZONTAL THROUGH BOLT
2 - VERTICAL BOLT(S)
3 - LOWER RADIATOR CROSSMEMBER
4 - FRONT ENGINE MOUNT
INSTALLATION
(1) Position front mount on lower radiator cross-
member.
(2) Loose install front mount to bracket through
bolt.
(3) Install front mount vertical bolts. Tighten bolts
to 61 N·m (45 ft. lbs.) (Fig. 75).
(4) Tighten horizontal through bolt to 61 N·m (45
ft. lbs.) (Fig. 75).
(5) Lower vehicle.
9 - 119
Advertisement
Table of Contents
