Table of Contents
Advertisement
9 - 116
ENGINE 2.4L DOHC
VIBRATION DAMPER (Continued)
(6) Support engine under oil pan with a wooden
block and screw jack (Fig. 68).
(7) Remove front and rear engine mount through
bolts.
(8) Slowly lower engine down with screw jack.
(9) Remove accessory drive belts (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
REMOVAL).
(10) Remove crankshaft damper bolt.
(11) Remove damper using Special Tool 8454
Puller and Insert 6827–A (Fig. 69).
Fig. 68 Vibration Damper - Removal
1 - VIBRATION DAMPER
2 - WOODEN BLOCK
3 - SCREW JACK
INSTALLATION
(1) Install crankshaft vibration damper using M12
1.75 x 150 mm bolt, washer, thrust bearing and nut
from Special Tool 6792 (Fig. 70).
(2) Install crankshaft vibration damper bolt and
tighten to 136 N·m (100 ft. lbs.).
(3) Install accessory drive belts (Refer to 7 -
COOLING/ACCESSORY DRIVE/DRIVE BELTS -
INSTALLATION).
(4) Raise engine with screw jack enough to install
front and rear engine mount through bolts. Torque
fasteners to 61 N·m (45 ft. lbs.).
(5) Install belt splash shield and right front wheel.
(6) Lower vehicle.
(7) Support engine under oil pan with wooden
block and floor jack.
(8) Slowly raise engine with floor jack until engine
mount bracket aligns with right side engine mount.
Fig. 69 Vibration Damper - Removal
1 - SPECIAL TOOL 6827-A INSERT
2 - SPECIAL TOOL 8454 PULLER
Install three vertical bolts to front engine bracket.
Torque fasteners to 61 N·m (45 ft. lbs.).
(9) Remove floor jack.
(10) Connect negative battery cable.
Fig. 70 Vibration Damper - Installation
1 - M12–1.75 × 150 MM BOLT, WASHER AND THRUST BEARING
FROM SPECIAL TOOL 6792
JR
Advertisement
Table of Contents
