Interconnecting The "Sto Active" Signal - Siemens Sinamics G110M Operating Instructions Manual

Advanced commissioning
6.13 Safe Torque Off (STO) safety function
Parameter
p9761
p9762
p9763
6.13.3.4

Interconnecting the "STO active" signal

If you require the feedback signal "STO active" of the inverter in your higher-level control
system, then you must appropriately interconnect the signal.
Procedure with STARTER and Startdrive
To interconnect the "STO active" checkback signal, proceed as follows:
1. Select the button for the feedback signal.
The screen form varies depending on the interface selected.
(A)
(B)
Figure 6-26
The screen form varies depending on the interface selected.
(A)
Figure 6-27
2. Select the signal that matches your particular application.
200
Description
Enter a password (factory setting: 0000 hex)
Permissible passwords lie in the range 1 ... FFFF FFFF.
New password
Password confirmation
Input terminals
PROFIsafe interface
Interconnecting "STO active" in STARTER
Control type
Interconnecting "STO active" in Startdrive
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 09/2017, FW V4.7.9, A5E31298649B AH