Backing Up And Transferring Settings Via Starter - Siemens Sinamics G110M Operating Instructions Manual

Data backup and series commissioning

7.2 Backing up and transferring settings via STARTER

7.2 Backing up and transferring settings via STARTER
With the supply voltage switched on,
you can transfer the converter settings
from the converter to a PG/PC, or the
data from a PG/PC to the converter.
This requires you to have installed the
STARTER commissioning tool on your
PG/PC.
You will find additional information about STARTER in Chapter:
with STARTER (Page 127).
Inverter → PC/PG
Procedure with STARTER
To back up the settings with STARTER, proceed as follows:
1. Go online:
2. Click the "Download project to PG" button:
3. Save the project:
4. Wait until STARTER reports that data backup has been completed.
5. Go offline:
You have backed up the settings with STARTER.
Procedure with Startdrive
To back up the settings with Startdrive, proceed as follows:
1. Go online.
2. Select "Online" > "Upload device to PG/PC."
3. Back up the project with "Project" > "Save."
4. Wait until Startdrive reports that data backup has been completed.
5. Go offline.
You have backed up the settings with Startdrive.
292
.
.
.
.
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 09/2017, FW V4.7.9, A5E31298649B AH
Quick commissioning