Drive Control Via Profibus Or Profinet; Receive Data And Send Data - Siemens Sinamics G110M Operating Instructions Manual

Specify deadband
Small signals of a few millivolts are often corrupted by interference in the cable. To be able
to enter a setpoint of exactly 0 V via an analog input, you must specify a deadband.
Figure 6-6
Table 6- 7
Parameter Description
p0764[0]
p0764[1]
6.4

Drive control via PROFIBUS or PROFINET

6.4.1

Receive data and send data

Cyclic data exchange
The inverter receives cyclic data from the higher-level control - and returns cyclic data to the
control.
Figure 6-7
Inverter and control system pack their data in telegrams.
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 09/2017, FW V4.7.9, A5E31298649B AH
Deadband of the analog input
Settings of the deadband of the analog inputs
Deadband of the analog input AI0 (factory setting: 0)
Deadband of the analog input AI1 (Factory setting: 0)
Cyclic data exchange
Advanced commissioning
6.4 Drive control via PROFIBUS or PROFINET
149