Torque Control - Siemens Sinamics G110M Operating Instructions Manual

6.17.3

Torque control

Torque control is part of the vector control and normally receives its setpoint from the speed
controller output. By deactivating the speed controller and directly entering the torque
setpoint, the closed-loop speed control becomes closed-loop torque control. The inverter
then no longer controls the motor speed, but the torque that the motor generates.
Figure 6-56 Simplified function diagram of the closed-loop torque control
Typical applications for torque control
The torque control is used in applications where the motor speed is specified by the
connected driven load. Examples of such applications include:
● Load distribution between master and slave drives:
The master drive is speed controlled, the slave drive is torque controlled.
● Winding machines
The most important settings
Prerequisites for the correct functioning of the torque control:
● You have set the motor data correctly during the quick commissioning
● You have performed a motor data identification on the cold motor
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 09/2017, FW V4.7.9, A5E31298649B AH
Quick commissioning (Page 111)
Advanced commissioning
6.17 Motor control
253