Adapting The Usb Interface - Siemens Sinamics G110M Operating Instructions Manual

Commissioning
5.4 Quick commissioning
Commissioning using STARTER
The following interfaces - which are control unit dependent - are available:
Table 5- 3
Type
PC connected to CU using
Interface
Restrictions
In the following the commissioning via USB is described.
5.4.5.1

Adapting the USB interface

Procedure
Proceed as follows to set the USB interface:
1. Switch on the converter power supply and connect the converter to the PC via USB.
2. The USB drivers are installed if you are connecting the converter and PC together for the
first time. Windows 7 automatically installs the drivers without you having to take any
action. For older Windows versions, acknowledge the corresponding screen forms with
OK.
3. Start the STARTER commissioning software.
4. If you are using STARTER for the first time, you must check the USB interface setting. To
do this, click in STARTER on
If the interface is appropriately set, then the "Accessible nodes" screen form lists the
converters, which are connected via the USB interface. In this case, go to Point 7.
If incorrectly set, then the "No additional nodes found" message is displayed.
5. Acknowledge this message, and set the "Access point" to "DEVICE (STARTER, Scout)"
and the "PG/PC interface" to "S7USB".
128
Connection possibilities for STARTER
USB cable
Mini-USB
USB PROFIBUS
PROFIBUS interface
M12 - 5 pole con-
nector
- up to 125 slaves
("Accessible nodes").
Distributed converter for SIMOGEAR geared motors
Operating Instructions, 09/2017, FW V4.7.9, A5E31298649B AH
PROFINET
PROFINET interface
M12 - 4 pole con-
nector
None