Replacement Of Memory Modules - IBM RS/6000 44P 270 Service Manual

Replacement of Memory Modules

1. With one hand, touch any metal surface of the chassis to minimize static electrical
charges, and then pick up the memory module.
2. Locate the memory module connector on the memory card.
Note: Memory modules must be installed in pairs and in the correct slot
3. Insert the memory module firmly into the connector.
4. Secure the memory module with the locking tabs located at each end of the
connector.
5. Replace the memory card into the system unit. See "Replacement of Memory
Cards" on page 233 for more information.
6. Replace the processor and memory card cover as described in "Replacement of
Processor and Memory Card Cover" on page 231.
7. Replace the system unit covers as described in "Replacement of Covers" on
page 230.
238
Service Guide
configuration. (Slots J1 and J2, J3 and J4, J5 and J6, and so on.)
Locking Tabs