Firmware Checkpoints - IBM RS/6000 44P 270 Service Manual

Table 1. Service Processor Checkpoints. (continued)
Checkpoint
E0E1
DIAG STBY
OK
STBY

Firmware Checkpoints

Firmware uses progress codes (checkpoints) in the range of E1xx to EFFF. These
checkpoints occur during system startup and can be useful in diagnosing certain
problems. Service processor checkpoints are listed in "Service Processor Checkpoints"
on page 71.
If you replace FRUs and the problem is still not corrected, go to "MAP 1540: Minimum
Configuration" on page 50 unless otherwise indicated in the tables.
If you replace FRUs or perform an action, and the problem is corrected, go to "MAP
410: Repair Checkout" in the RS/6000 and Eserver pSeries Diagnostics Information
for Multiple Bus Systems.
Description
Processor card pulled out
successfully of reset.
Service processor ready. The system
unit was shutdown in service mode
by the operating system; however,
the system unit is still powered on.
Service processor ready; waiting for
power-on
Service processor ready. System was
shutdown by the operating system
and is still powered on.
Action/ Possible Failing FRU
1. Remove processor card in slot
(J8) (if installed) and see if the
problem is resolved. If problem is
resolved replace processor card.
If not, continue.
2. Exchange processor card in slot
(J6) with the processor card
removed in step 1 (or replace
processor card if only one
processor card exists) and see if
problem is resolved. If problem is
resolved replace the processor
card. If not, continue.
3. Go to "MAP 1540: Minimum
Configuration" on page 50.
This condition can be requested by a
privileged system user with no faults.
See service processor error log for
possible operating system fault
indications.
None. Normal operation.
1. If this problem persists, go
to"MAP 1540: Minimum
Configuration" on page 50.
2. This condition can be requested
by a privileged system user with
no faults. See service processor
error log for possible operating
system fault indications.
Chapter 4. Checkpoints
75