IBM RS/6000 44P 270 Service Manual page 113

Table 3. Firmware Error Codes. (continued)
Error Code Description
20E00000 Power-on password entry error.
20E00001 Privileged-access password entry
error.
20E00002 Privileged-access password
jumper not enabled.
20E00003 Power-on password must be set
for unattended mode.
20E00004 Battery drained or needs
replacement.
20E00005 EEPROM locked
20E00008 CMOS reinitialized due to
corruption.
20E00009 Invalid password entered - system
locked.
20E0000C Failed to open RTC device tree
node
20E00017 Cold boot needed for password
entry.
20EE0003 IP parameter requires 3 dots "."
20EE0004 Invalid IP parameter.
20EE0005 Invalid IP parameter (>255)
Action / Possible Failing FRU
The password has been entered
incorrectly.
Retry installing the password.
The password has been entered
incorrectly.
Retry installing the password.
The privileged-access password jumper
is not in the correct position for
password initial entry.
Consult the system's user's guide for
jumper location and position.
Unattended mode requires the setting
of the power-on password before it is
enabled.
1. Replace battery.
2. Replace I/O board. (See note on
page 93.)
1. Turn off, turn on system unit.
2. Replace I/O board. (See note on
page 93.)
1. Replace battery, restore NVRAM
data (passwords, startup data).
2. Replace I/O board. (See note on
page 93.)
The password has been entered
incorrectly 3 times.
Turn off, then turn on the system unit,
then enter the password correctly.
1. Turn off, turn on system unit.
2. Replace I/O board. (See note on
page 93.)
Turn off, turn on system unit.
Enter valid IP parameter.
Example: 000.000.000.000
Enter valid (numeric) IP parameter.
Example: 000.000.000.000
Enter valid (numeric) IP parameter in
the range of 0 to 255.
Example: 255.192.002.000
Chapter 5. Error Code to FRU Index
95