IBM RS/6000 44P 270 Service Manual page 127

Table 3. Firmware Error Codes. (continued)
Error Code Description
2B2xxx22 Processor disabled.
2B2xxx31 Processor failed.
2B2xxx42 Unsupported processor type.
2BA00xxx Service processor
2BA00000 Service processor POST failure.
2BA00012 Service processor reports self-test
failure.
2BA00013 Service processor reports bad
NVRAM CRC.
2BA00014 Service processor reports bad
service processor firmware.
2BA00017 Service processor reports bad or
low battery.
Action / Possible Failing FRU
Processor card, where xxx indicates the
processor type as follows:
651 200 MHz processor card with
1 MB of L2 cache.
654 200 MHz processor card with
4 MB of L2 cache.
754 375 MHz 1- way processor
card with 4 MB of L2 cache.
764 375 MHz 2- way processor
card with 4 MB of L2 cache.
768 375 MHz 2- way processor
card with 8 MB of L2 cache.
7A8 450 MHz 2- way processor
card with 8 MB of L2 cache.
Processor card. See error code
2B2xxx22 for xxx definitions.
Processor card. See error code
2B2xxx22 for xxx definitions.
1. Unplug the system power cable and
wait until the system power indicator
remains off and the operator panel
is blank.
2. Plug the system power cable back
in and retry the operation.
3. Replace the I/O board. (See note on
page 93.)
1. Unplug the system power cable and
wait until the system power indicator
remains off and the operator panel
is blank.
2. Plug the system power cable back
in and retry the operation.
3. Replace the I/O board. (See note on
page 93.)
1. If problem persists, replace battery.
2. Replace the I/O board. (See note on
page 93.)
Use service processor firmware diskette
to reprogram firmware.
1. Replace the battery.
2. Replace the I/O board. (See note on
page 93.)
Chapter 5. Error Code to FRU Index
109