Replacement Of Processor Card - IBM RS/6000 44P 270 Service Manual

6. Remove the card from the connector. Be sure to store the processor card in a safe
place.

Replacement of Processor Card

Installing a processor card into your system unit may require updating the firmware. Go
to Appendix C, "Firmware Updates", on page 287.
Attention: Both processor cards must be of the same speed.
1. If you have not already done so, open the card camming latches on both ends of
the card connector.
Attention: When you remove a card make sure that you do not let it come into
2. Place the processor card in the processor card guide rails.
3. Carefully align the processor card with the card connector.
4. Firmly insert the processor card into the card connector.
240
Service Guide
contact with the card below it.