IBM RS/6000 44P 270 Service Manual page 51

Symptom
The System Management Services menu is
displayed.
You have a problem that does not prevent the
system from booting.
You have an SRN.
You suspect a cable problem.
You do not have a symptom.
You have not determined a symptom.
You Cannot Find the Symptom in this Table
All other problems.
Action
The device or media you are attempting to boot
from may be faulty.
1. Check the SMS error log for any errors. To
check the error log:
a. Choose error log from the utilities menu.
b. If an error is logged, check the time
stamp.
c. If the error was logged during the current
boot attempt, record it.
d. Look up the error in Chapter 4,
"Checkpoints", on page 71 and perform
the listed action.
e. If no recent error is logged in the error
log, continue to the next step below.
2. Try to boot from an alternate boot device
connected to the same controller as the
original boot device. If the boot succeeds,
replace the original boot device. (For
removable media devices try the media first.)
3. Go to "MAP 1540: Minimum Configuration" on
page 50.
Go to the Fast Path MAP in the RS/6000 and
Eserver pSeries Diagnostics Information for
Multiple Bus Systems.
Go to the Fast Path MAP in the RS/6000 and
Eserver pSeries Diagnostics Information for
Multiple Bus Systems.
See the RS/6000 and Eserver pSeries
Adapters, Devices, and Cable Information for
Multiple Bus Systems.
Go to MAP 0020 in the RS/6000 and Eserver
pSeries Diagnostics Information for Multiple Bus
Systems.
Go to "MAP 1020: Problem Determination" on
page 34.
Go to "MAP 1020: Problem Determination" on
page 34.
Chapter 3. Maintenance Analysis Procedures
33