Step 1540-16 - IBM RS/6000 44P 270 Service Manual

Step 1540-16

The system is working correctly with this configuration. One of the FRUs (adapters) that
you removed is probably defective.
1. Turn off the power and remove the power cable.
2. Install a FRU (adapter) and connect any cables and devices that were attached to
it.
3. Plug in the power cable (and wait for OK on the operator panel display)
4. Turn on the power.
5. If the Console Selection screen is displayed, choose the system console.
6. After the keyboard indicator appears, press the F5 key on the directly attached
keyboard or the number 5 key on an ASCII terminal keyboard.
7. Enter the appropriate password if you are prompted to do so.
Is the "Please define the System Console" screen displayed?
NO
YES
64
Service Guide
Go to "Step 1540-17" on page 65.
Repeat this step until all of the FRUs (adapters) are installed.
Go to "MAP 410: Repair Checkout" in the RS/6000 and Eserver pSeries
Diagnostics Information for Multiple Bus Systems.