IBM RS/6000 44P 270 Service Manual page 253

9. Close the camming latches to secure the card into the connector.
10. Make sure that the tabs on the new card are captured by the latches.
Note: Push the card in with your thumb to make sure that the card is seated
properly.
11. Install the memory card shield between the two memory cards.
12. Replace the processor and memory card cover as described in "Replacement of
Processor and Memory Card Cover" on page 231.
13. Replace the system unit covers as described in "Replacement of Covers" on
page 230.
Chapter 9. Removal and Replacement Procedures
235