IBM RS/6000 44P 270 Service Manual page 281

5. Enter the VPD serial number.
Note: The serial number MUST be entered correctly. Enter the last seven digits
only. Do not include the dash (-) in the serial number as a digit. If the serial
number is not entered correctly, a new operator panel will need to be ordered
and installed.
VPD Serial Number has been programmed
successfully.
The current TM field is: 7044-270
Do you want to change the TM field (y/n)?
6. Enter yes (y) if the system unit's Type/Model (TM) you are working on is different
from the one listed on the screen.
7. Enter the Type and Model number of the system unit.
Enter the TM data (8 ASCII digits): xxxx-xxx
TM has been programmed successfully
The current MN field is 1980
Do you want to change the MN field (y/n)?
8. The MN field is for manufacturing use only. Enter no (n) to change the MN field.
9. Enter 99 at the command line of the Main Menu to exit.
Chapter 9. Removal and Replacement Procedures
263