IBM RS/6000 44P 270 Service Manual page 261

1. If you have not already done so, shut down the system as described in "Stopping
the System Unit" on page 224.
2. If you have not already done so, unplug the system unit power cable from the
electrical outlet.
3. If you have not already done so, remove the front, rear, and left side covers as
described in "Removal of Covers" on page 226.
4. Carefully grasp the adapter by the edges and align the adapter with the
expansion-slot connector.
5. Press the adapter firmly into the expansion-slot connector.
6. Use the screw you removed earlier from the expansion-slot cover to secure the
adapter card bracket to the system unit.
7. Connect any cables you removed earlier to the adapter.
8. Replace the system unit covers as described in "Replacement of Covers" on
page 230.
Chapter 9. Removal and Replacement Procedures
243