IBM RS/6000 44P 270 Service Manual page 117

Table 3. Firmware Error Codes. (continued)
Error Code Description
21F20xxx SCSI read/write optical.
22000001 Internal wrap test failed.
22001001 Internal wrap test failed.
22002001 Adapter failed to complete
hardware initialization.
22010001 Adapter failed to complete
hardware initialization.
22011001 Adapter failed to complete
hardware initialization.
25000000 Memory controller failed.
25010xxx Flash update problem
25010000 No diskette in drive.
25010001 Diskette seek error.
25010002 Diskette in drive does not contain
an *.IMG file.
25010003 Cannot open OPENPROM
package.
25010004 Cannot find OPENPROM node.
25010006 System id does not match image
system id.
25010007 Image has bad CRC.
25010008 Flash is write-protected, update
cancelled.
25010009 Flash module is unsupported or
not recognized.
2501000A Flash write-protected.
2501000C Failed write to flash memory.
Action / Possible Failing FRU
Refer to 21A00xxx for a description and
repair action for the xxx value.
Replace adapter.
Replace adapter.
Replace adapter.
Replace adapter.
Replace adapter.
Replace the system board.
Insert diskette containing firmware
image.
1. Retry function.
2. Replace diskette drive.
3. Replace diskette cable.
4. Replace I/O board. (See note on
page 93.)
Insert diskette with firmware update file.
Replace I/O board. (See note on page
93.)
Replace I/O board. (See note on page
93.)
Make sure correct firmware update
diskette is being used with this system.
Replace firmware update diskette.
1. Turn off, turn on system unit and
retry.
2. Replace I/O board. (See note on
page 93.)
Make sure correct firmware update
diskette is being used with this system.
1. Turn off, turn on system unit, retry.
2. Replace I/O board. (See note on
page 93.)
1. Turn off, turn on system unit, retry.
2. Replace I/O board. (See note on
page 93.)
Chapter 5. Error Code to FRU Index
99