Replace The Fuel Filter/Water Separator - Deutz Models - Genie GS-3384 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST C PROCEDURES
C-4
Replace the Diesel Fuel
Filter/Water Separator -
Deutz Models
Genie specifications require that this procedure be
performed every 500 hours or semi-annually,
whichever comes first.
Replacing the diesel fuel filter/water separator is
essential to good engine performance and service
life. A dirty or clogged filter/water separator may
cause the engine to perform poorly and continued
use may cause component damage. Extremely
dirty conditions may require that the filter/water
separator be replaced more often.
Explosion and fire hazard. Engine
fuels are combustible. Replace the
fuel filter/water separator in an
open, well-ventilated area away
from heaters, sparks, flames and
lighted tobacco. Always have an
approved fire extinguisher within
easy reach.
Note: Perform this procedure with the engine off.
1 Release the latches on the engine tray and fully
slide the engine tray out.
2 Insert a 6 inch / 15 cm screwdriver or rod into
the engine tray lock hole located near the
engine tray roller wheels to prevent the engine
tray from moving.
3 Turn the manual fuel shutoff valves, located at
the fuel tank, to the closed position.
3 - 32
4 Remove the fuel filter/water separator with a
filter wrench.
5 Fill the new filter with fresh diesel fuel and apply
a thin layer of diesel fuel to the new fuel filter
gasket.
6 Install the new filter and tighten it securely by
hand. Clean up any diesel fuel that might have
spilled during the procedure.
7 Use a permanent ink marker to write the date
and number of hours from the hour meter on the
filter.
8 Turn the manual fuel shutoff valves, located at
the fuel tank, to the open position.
9 Start the engine from the ground controls and
inspect the fuel filter for leaks.
GS-84 • GS-90
January 2013
a oil filter
b fuel filter/water separator
Explosion and fire hazard. If a fuel
leak is discovered, keep any
additional personnel from entering
the area and do not operate the
machine. Repair the leak
immediately.
Part No. 84793
a
b