Platform Extension Deck - Genie GS-3390 Service Manual

July 2007
REV C
2-2

Platform Extension Deck

How to Remove a Platform
Extension Deck
Note: Perform this procedure with the platform in
the stowed position and the platform extension
deck(s) fully retracted and locked in position.
Note: If the machine is equipped with the dual
extension deck option, repeat this procedure for
the other platform extension deck.
1 Steer end extension deck: Remove the
platform controls from the platform and lay them
off to the side of the machine.
2 Remove the retaining pins from the four black
plastic railing guides. Lower the railing guides in
the down direction.
3 Remove the mounting fasteners from the
platform extension deck stop brackets at both
sides of the deck.
Note: The platform extension deck stop brackets
are located above the platform V-roller wheels.
4 At the platform extension deck to be removed,
position a fork lift with the forks even with the
bottom of the platform extension deck.
5 Lift the platform extension deck lock handle.
6 Carefully slide the platform extension deck out
until the platform extension deck makes contact
with the carriage on the forklift.
Part No. 72863
7 Attach a strap from the platform extension deck
railings to the carriage on the forklift to help
support the platform extension deck.
8 Remove the three V-roller and extension deck
lock bracket mounting fasteners from the
extension deck at the tank side of the machine.
9 Carefully pull the V-roller and extension deck
lock assembly out of the extension deck.
10 Remove the fasteners from the roller wheels
located under the platform extension deck.
Remove the roller wheels.
11 Carefully slide the platform extension deck out
of the platform and place it on a structure
capable of supporting it.
GS-3390 • GS-4390 • GS-5390
Section 4 • Repair Procedures
PLATFORM COMPONENTS
Crushing hazard. The platform
extension deck could become
unbalanced and fall when
removed from the machine if not
properly supported and secured to
the forklift.
4 - 17