To Route A Call Using The Least Cost Routing Feature; Sending A Forward Recall While On A Call; To Send A Forward Recall Signal To An Exchange Or A Pabx; Account Codes - BT Versatility V16 Owner's Manual

BT Versatility
Owners Manual
Additional call features
• Scroll Down until 'LCR Timebands' is displayed.
• Select LCR on times
• You can enter two 'On' times.
• Select LCR off Times
• You can enter two times at which the LCR facility is deactivated
A Third option 'LCR weekend' is offered. When this is selected the LCR service remains
active from Friday night to Monday morning, all off times over the weekend are ignored.
Press the Hands-free Key to finish programming.

To route a call using the Least Cost Routing feature

• Select a Line Key, or dial a code for a Line (9, 760 – 769) and select 'Send digits'.
• Dial a valid input code.
• When a Line is selected, dial the telephone number you wish to reach.
Your call will then be connected with the output code being dialled before the telephone
number.
Note: Any Line Key or Line code (9, 760 – 769) can be selected above. However, the system will select the
line for the call based on the input code.

Sending a Forward Recall while on a call

A Forward Recall signal may be required if you are using certain network services on
standard Analogue exchange Lines, or if your BT Versatility is connected to another
telephone system (PABX) via one of the Line interfaces.
The Forward Recall feature allows you to send a hold signal forward on the Line to the
exchange or PABX. To send a hold signal, you must be on a call or have dialled at least
one digit of the number you are calling.

To send a Forward Recall signal to an exchange or a PABX

• From a Featurephone, select 'Forward recall' on the Display.
From a standard telephone, the code is R722.

Account Codes

A programming option can be set which allows codes of four digits to be associated with
external calls, both incoming and outgoing, and these codes are presented on the Call
Logging output. Two options are available. The first is that the entry of account codes is
'Optional' and the user can choose to enter the code or not. The second option is 'Forced'
and in this case the user must enter the code before they can make an external call.

To set up the Account Code operation

• From the Programming Extension, press the Programme Key .
• Select 'System programming'.
• Enter the System Programming Password and select 'System'.
• Press the Scroll Down Key until 'Account Codes' is displayed.
• Select 'Account Codes'.
• Select 'Account Codes on'.
39