Table of Contents
Advertisement
not soak, iron, dry clean or bleach the strap. Do not stretch the strap or bend
the electrode areas sharply.
Check the washing instructions on the label of the strap.
Stride Sensor Bluetooth ® Smart, Speed Sensor Bluetooth ® Smart
and Cadence Sensor Bluetooth ® Smart
Clean the sensors with a mild soap and water solution and rinse them with
clean water. To maintain the water resistance, do not wash the sensors with a
pressure washer. Do not immerse the speed sensor, cadence sensor or
stride sensor in water. Never use alcohol or any abrasive material such as
steel wool or cleaning chemicals. Avoid hard hits to the sensors, as these may
damage the sensor units.
Storing
Keep your training device and sensors in a cool and dry place. Do not keep
them in a damp environment, in non-breathable material (a plastic bag or a
sports bag) nor with conductive material (a wet towel). Do not expose the
training device to direct sunlight for extended periods, such as by leaving it in
a car or mounted on the bike mount.
It is recommended to store the training device partially or fully charged. The
battery slowly loses its charge when it is stored. If you are going to store the
training device for several months, it is recommended to recharge it after a
few months. This will prolong the battery lifetime.
Dry and store the strap and the connector separately to maximize the heart
rate sensor battery lifetime. Keep the heart rate sensor in a cool and dry
place. To prevent snap oxidation, do not store the heart rate sensor wet in
non-breathing material, such as a sports bag. Do not expose the heart rate
sensor to direct sunlight for extended periods
164
Advertisement
Table of Contents
