Table of Contents
Advertisement
The training device should not be used for obtaining environmental
measurements that require professional or industrial precision.
Interference During Training
Electromagnetic Interference and Training Equipment
Disturbance may occur near electrical devices. Also WLAN base stations may
cause interference when training with the training device. To avoid erratic
reading or misbehavior, move away from possible sources of disturbance.
Training equipment with electronic or electrical components such as LED
displays, motors and electrical brakes may cause interfering stray signals. To
solve these problems, try the following:
1Remove the heart rate sensor strap from your chest and use the training
equipment as you would normally.
2Move the training device around until you find an area in which it displays
no stray reading or does not flash the heart symbol. Interference is often
worst directly in front of the display panel of the equipment, while the left
or right side of the display is relatively free of disturbance.
3Put the heart rate sensor strap back on your chest and keep the training
device in this interference-free area as much as possible.
If the training device still does not work with the training equipment, it may
be electrically too noisy for wireless heart rate measurement. For further
information, www.polar.com/support.
Parts of V800 are magnetic. It may attract metallic materials and it's magnetic
field may interfere with a compass. To avoid interference, it is recommended
to wear your compass on one arm (at the level of your chest) and your V800
on the other arm's wrist. Do not place credit cards or other magnetic storage
media near V800, because information stored on them may be erased.
175
Advertisement
Table of Contents
