Pair A Stride, Speed Or Cadence Sensor With V800 - Polar Electro V800 User Manual

Pair a Stride, Speed or Cadence Sensor with V800

Before pairing a stride sensor, cadence sensor or speed sensor, make sure
they have been correctly installed. For more information on installing the
sensors see their user manuals.
There are two ways to pair a sensor with your V800:
1Press START in time view to enter pre-training mode.
V 800 starts searching for your sensor. 2
3Stride sensor: Touch your stride sensor with V800, and wait for it to
l
be found.
4Cadence sensor: Rotate the crank a few times to activate the sensor.
l
The flashing red light in the sensor indicates that the sensor is activ-
ated.
5Speed sensor: Rotate the wheel a few times to activate the sensor.
l
The flashing red light in the sensor indicates that the sensor is activ-
ated.
6The device ID
Yes.
7Pairing completed
or
1Go to General Settings > Pair and sync > Pair other device
START.
2V800 starts searching for your sensor.
3Once the sensor is found, the device ID
displayed.
Pair Polar RUN/CAD/SPD xxxxxxxx
is shown when you are done.
Polar RUN/CAD/SPD xxxxxxxx
44
is displayed. Choose
and press
is