Pairing A New Cadence Sensor With The Training Computer; Pairing A New Stride Sensor With The Training Computer; Calibrate The Polar S3+ Stride Sensor - Polar Electro RC3 GPS User Manual

8. To return to time mode, press and hold the BACK button.

Pairing a New Cadence Sensor with the Training Computer

Make sure the cadence sensor has been correctly installed. For more information on installing the cadence
sensor refer to the user manual of the cadence sensor or to the video tutorial at
http://www.polar.com/en/polar_community/videos [http://www.polar.com/en/support/video_tutorials].
You can have two bikes on the training computer. Each bike has to have the sensors separately taught.
You can only teach one cadence sensor to one bike. If you have two bikes, both of them can use the same
cadence sensor. Or, they can have their own set of sensors. When you pair a new sensor to a bike that
already has a previously taught sensor in the memory, the new sensor replaces the previous one.
1. Go to >
MENU Settings
>
settings Cadence sensor
2. (START)
Press OK to start test drive
3. Press START and
Searching new cadence sensor
for the cadence sensor signal. Rotate the wheel a few times to activate the sensor. The flashing red light
on the sensor indicates that the sensor is activated.
4. Once the new cadence sensor is identified,
5. If the search is not successful,
,
further. Try again? YES / NO
6. Select to start the search again.
YES
7. Select to cancel the searching.
NO
8. To return to time mode, press and hold the BACK button.

Pairing a New Stride Sensor with the Training Computer

Make sure the stride sensor has been correctly attached to your shoe. For more information on setting up
the stride sensor refer to the user manual of the stride sensor or to the video tutorial at
http://www.polar.com/en/polar_community/videos [http://www.polar.com/en/support/video_tutorials].
You can only pair one stride sensor to the training computer at a time. If you pair a new sensor, the new
sensor always replaces the previous one you had paired. The stride sensor can only be paired to the
Running sport profile.
1. Go to >
MENU Settings
2.
Searching for new stride sensor
sensor signal.
3. Once the new stride sensor is identified,
4. If the search is not successful,
,
further. Try again? YES / NO
5. Select to start the search again.
YES
6. Select NO to cancel the searching.
7. To return to time mode, press and hold the BACK button.

Calibrate the Polar s3+ Stride Sensor

Polar s3+ stride sensor can be set on only for the
Calibration of the stride sensor improves the accuracy of speed/pace and distance measurements. It is
recommended that you calibrate the stride sensor before using it for the first time, if there are significant
changes in your running style, or if the position of the stride sensor on the shoe is dramatically changed
(e.g. if you have new shoes or if you switch the sensor from your right shoe to your left one). You can
calibrate the stride sensor by running a known accurate distance, or by setting the calibration factor
manually. The calibration should be done at the speed you normally run. If you run at different speeds,
the calibration should be done at your average speed.
> >
Sport profiles Cycling (Bike 1)
> and press START .
Search new
is displayed.
Cadence sensor found
Cadence sensor not found
is displayed.
> >
Sport profiles Running
is displayed. The training computer starts searching for the stride
Stride sensor found
Stride sensor not found
is displayed.
Running
/ >
Cycling (Bike 2)
is displayed. The training computer starts searching
is displayed. Pairing is complete.
or
Other cadence sensors interfering. Move
> >
Stride sensor Search new
is displayed. Pairing is complete.
or
Other stride sensors interfering. Move
sport profile.
ENGLISH
/
Bike 1 settings Bike 2
and press START .
New Accessory 39