System Commands - Symmetricom TimeProvider 1100 Reference Manual

Appendix A
Table A-2. System Commands
Command
Copy Memory (CPY-MEM), on
page 36
Retrieve Date (RTRV-DAT), on
page 99
Edit Date (ED-DAT), on page 44
Retrieve Equipment
(RTRV-EQPT), on page 101
Edit Equipment (ED-EQPT), on
page 45
Retrieve Sync (RTRV-SYNC), on
page 123
Edit Sync (ED-SYNC), on page 55 Changes factory settings and input and output port parameter
Retrieve Circuit Identification
(RTRV-CKTID), on page 84
Edit Circuit Identifier (ED-CKTID),
on page 41
Retrieve Attribute (RTRV-ATTR),
on page 76
Initialize Event Log (INIT-LOG), on
page 66
Retrieve Log (RTRV-LOG), on
page 109
Initialize System (INIT-SYS), on
page 67
Retrieve System Mode
(RTRV-SYS-MODE), on page 125
Set System Mode
(SET-SYS-MODE), on page 134
Operate Alarm Cutoff
(OPR-ACO-ALL), on page 69
Set Source Identifier (SET-SID),
on page 133
Retrieve Alarm Condition
(RTRV-ALM), on page 73
140 TimeProvider TL1 Reference Guide
Saves a module's Istate in another module's flash memory
Retrieves the system date, time, and local offset
Changes the system date and time
Retrieves currently provisioned equipment parameters
Used to provision equipment parameters
Retrieves equipment parameters associated with provisioning of
the synchronization interfaces for the system inputs and outputs
settings
Retrieves the circuit ID for the specified input or output
Changes the circuit ID for the specified input or output
Retrieves the alarm level set for a specified alarm
Clears the event log on the IMC module
Retrieves all events in the event log
Initializes the specified module, or the system
Retrieves the TimeProvider's currently provisioned system
operating mode
Provisions the TimeProvider system's operating mode to SSU,
SUB, or PRR
Deactivates (opens) the minor, major, and critical audible alarm
relays
Provisions the TimeProvider system's source identifier (SID)
Retrieves information on currently active alarms
Description
097-58001-01 Revision E – September 2006