Symmetricom TimeProvider 1100 Reference Manual page 149

Table B-1. Alarms (Continued)
Alarm ID
Alarm Condition
or
Description
CONDTYPE
INPFRQ The specified input
port's calculated
received frequency is
exceeding the pull-in
range of the local
oscillator. The received
signal's calculated
frequency alarmed
condition disqualifies
the input as a possible
reference. After
INPFRQ is set, the
alarm clears when the
input frequency is within
the defined pull-in range
limits.
INPPHASE The specified input port
has a excessive phase
measurement that is
disqualifies it from being
used.
FFOFF Input has exceeded the
Fractional Frequency
Offset threshold.
MTIE Input has exceeded at
least one of the MTIE
alarm thresholds.
EXDSC Input has had excessive
discontinuities. This is
indicated when there
are more than 3 signal
faults of the same type
within a 5-minute
window. The alarm
clears when the 5-
minute window contains
less than 3 alarms of the
same type.
097-58001-01 Revision E – September 2006
Error
AID Service
Delay
Type Affecting
Default
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
Appendix B Alarms
Alarm Default
Error
Level
Delay
Editable
SSU PRS SUB
NO MN MN
NO MN MN
NO MN MN
NO MN MN
NO MN MN
TimeProvider TL1 Reference Guide 149
NR
MN
MN
MN
MN