Symmetricom TimeProvider 1100 Reference Manual page 146

Appendix B Alarms
Table B-1. Alarms (Continued)
Alarm ID
Alarm Condition
or
Description
CONDTYPE
CLKWARM The local oscillator on
the specified IOC is in
Warm-up mode.
SYNTHEOR The synthesizer
generating the modules
stable output frequency
has reached the defined
End-of-Range for the
type of oscillator used
on the IOC.
ANTCOMM Loss of communications
to antenna
GPSPOS The GPS Antenna's
position is unknown
GPSPWR TimeProvider power to
TPIU is either high or
low.
GPSSYS GPS System is
indicating an error with
BIST (at startup)
TRAIM, and/or
UTC/ephemeris data.
GPSTRK The GPS Engine is not
tracking any satellites.
INPDISQ The specified input was
Disqualified or Qualified
as a possible system
reference. The fault
condition must be
continuously present for
the Fault Delay Time
(FLTDELAY) before
disqualifying the input
as a possible reference.
After INPDISQ is set the
alarm clears when the
input signal is fault free
for the Clear Delay Time
(CLRDELAY).
146 TimeProvider TL1 Reference Guide
Error
AID Service
Delay
Type Affecting
Default
EQPT SA IMMED
EQPT SA IMMED
<aid> = GPS
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
T1 NSA FLT
DELAY
Alarm Default
Error
Level
Delay
Editable
SSU PRS SUB
NO MN MN
NO MJ MJ
NO MN MN
YES NA NA
NO MN MN
YES MN MN
YES MN MN
YES MN MN
097-58001-01 Revision E – September 2006
MN
MJ
MN
NA
MN
MN
MN
MN