Symmetricom TimeProvider 1100 Reference Manual page 151

Table B-1. Alarms (Continued)
Alarm ID
Alarm Condition
or
Description
CONDTYPE
INPLOS The specified input port
has Loss Of Signal.
When LOS is detected,
the input is removed
from the possible
reference list. The LOS
must be continuously
present for the Fault
Delay Time (FLTDELAY)
before disqualifying the
input as a possible
reference. After INPLOS
is set, the alarm clears
when the input signal is
LOS free for the Clear
Delay Time
(CLRDELAY).
INPOOF The specified input port
is receiving an Out Of
Frame signal. When
OOF is detected, the
input is removed from
the possible reference
list. The OOF must be
continuously present for
the Fault Delay Time
(FLTDELAY) before
disqualifying the input
as a possible reference.
After INPOOF is set, the
alarm clears when the
input signal is OOF free
for the Clear Delay Time
(CLRDELAY).
INPPHASE The specified input port
has a excessive phase
measurement that is
disqualifies it from being
used.
INPQL Alarm indicating the
received SSM is of
lesser quality than the
Local Oscillator's
QLEVEL for a specified
input.
097-58001-01 Revision E – September 2006
Error
AID Service
Delay
Type Affecting
Default
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
Appendix B Alarms
Alarm Default
Error
Level
Delay
Editable
SSU PRS SUB
NO MN MN
NO MN MN
NO MN MN
NO MN MN
TimeProvider TL1 Reference Guide 151
MN
MN
MN
MN