Symmetricom TimeProvider 1100 Reference Manual page 143

Appendix B Alarms
Table B-1 provides a list of all alarm identifiers and a description of the alarm. The
AID type indicates if the event occurred in the unit (EQPT) or externally from an
input or output (T1). The table also shows if the alarm is service affecting (SA), or
non-service affecting (NSA)
Table B-2 is a list of alarm identifiers and conditional descriptions. The set and clear
alarm conditional description is the text that appears when the event occurs. In the
following example,
description.
"INP1,T1:CR,INPLOS,NSA,05-01-17,15-10-03,,:\"LOS FAULT\""
Table B-1. Alarms
Alarm ID
Alarm Condition
or
Description
CONDTYPE
COMPAT System components (for
example IOC software
and hardware) are not
compatible.
EXTALM1 The external alarm used
to monitor alarms
generated by external
equipment.
EXTALM2 The external alarm used
to monitor alarms
generated by external
equipment.
PWRA The IMC has detected
the loss of power on the
A connection
PWRB The IMC has detected
the loss of power on the
B connection.
IOC1EQPT IOC1EQPT indicates that
the IOC was physically
inserted or removed from
the system.
097-58001-01 Revision E – September 2006
is the Alarm ID and
INPLOS
AID Service
Type Affecting
<aid> = SYS
EQPT NSA
EQPT NSA
EQPT NSA
EQPT NSA
EQPT NSA
EQPT NSA
is the set condition
LOS FAULT
Error Error
Delay Delay
Default Editable
SSU PRS SUB
IMMED NO MJ
IMMED NO MJ
IMMED NO CR
IMMED NO MJ
IMMED NO MJ
IMMED NO MJ
TimeProvider TL1 Reference Guide 143
Alarm Default
Level
MJ MJ
MJ MJ
CR CR
MJ MJ
MJ MJ
MJ MJ