Symmetricom TimeProvider 1100 Reference Manual page 48

Chapter 2 TL1 Command Syntax and Description
Edit Equipment (ED-EQPT)
Table 2-5. ED-EQPT – Keywords and Values (Continued)
<keyword> <value>
ST2 /
CLKTYPE
TYPEII
Rubidium
ST3E /
TYPEI
Quartz
IOCSTATE INSRV
OOSRV
INSTATE ENABLE
DISABLE
MONITOR The specified input is in monitor-only mode.
MODE AUTO
MANUAL
POS LAT
Note: The
LONG
position can
only be set
ELEV
when MODE =
Manual.
ELEVMASK 5° to 45°
48 TimeProvider TL1 Reference Guide
Description
The assumed SSM quality level for the Rubidium IOC
card's clock is set to either ANSI stratum 2 traceable
(ST2) or ETSI Type 2 (TYPEII) traceable. This value is
used for placing SSM bits in the output stream when in
Holdover mode. Any input to the unit that is of lesser
quality than ST2 / TYPEII is not used as a reference.
Note: ST2 and TYPEII can only be provisioned on the
Rubidium IOC card; they cannot be provisioned on the
Quartz IOC card.
The assumed SSM quality level for the Quartz IOC card's
clock is set to either ETSI Type 1 (TYPEI) or ANSI
(ST3E). This value is used for placing SSM bits in the
output stream when in Holdover mode. Any input to the
unit that is of lesser quality than TYPEI / ST3E is not used
as a reference.
Note: ST3E and TYPEI can only be provisioned on the
Quartz IOC card; they cannot be provisioned on the
Rubidium IOC card.
The IOC card is placed into service.
The IOC card is taken out of service.
Note: A module that was taken out of service is not
selectable by the system to generate outputs or monitor
inputs, and no alarms are generated by the module.
<aid> = GPS
The specified input is enabled.
The specified input is disabled.
Note: In monitor-only mode, the performance of the input
is monitored and it is monitored for signal faults, but
cannot be selected as a system reference.
The antenna position (latitude, longitude, and height) is
automatically computed or re-computed and then set.
The user sets the antenna position (latitude, longitude,
and elevation) using the POS keyword.
dd-mm-ss.ssN or dd-mm-ss.ssS
dd-mm-ss.ssE or dd-mm-ss.ssW
±hhhh.h elevation (altitude) in meters
The specified elevation mask.
097-58001-01 Revision E – September 2006
Default
TYPEI /
TYPEII
INSRV
DISABLE
AUTO
N/A
10°