Symmetricom TimeProvider 1100 Reference Manual page 60

Chapter 2 TL1 Command Syntax and Description
Edit Sync (ED-SYNC)
Table 2-6. ED-SYNC – Keywords and Values (Continued)
<keyword> <value>
FRMTYPE ISOLATED_
(cont'd) 1
FREEFLT ON
SQUELCH
AIS
HOLDFLT ON
SQUELCH
AIS
SSMENA ENABLE
DISABLE
SSMBIT 4
5
6
7
8
ALL
RTMLBO 0
Note: For the E1
1
Retimer, the IPNV
(Invalid
2
Parameter) DENY
3
code is returned.
4
FREEFLT CUTTHRU
RETIME
60 TimeProvider TL1 Reference Guide
Description
The framing type generated by the specified output
group is provisioned as an 'isolated one' test pattern.
Outputs are generated based on system SSM when
the Local Oscillator enters Free-run mode.
Outputs are squelched (turned off) when the Local
Oscillator enters Free-run mode.
Outputs generate an AIS signal when the Local
Oscillator enters Free-run mode.
Outputs are generated based on system SSM when
the Local Oscillator enters Holdover mode.
Outputs are squelched (turned off) when the Local
Oscillator enters Holdover mode.
Outputs generate an AIS signal when the Local
Oscillator enters Holdover mode.
ESF or E1 (CCS) outputs generate SSMs.
ESF or E1 (CCS) outputs do not generate SSMs.
The output SSM is placed in bit position 4.
The output SSM is placed in bit position 5.
The output SSM is placed in bit position 6.
The output SSM is placed in bit position 7.
The output SSM is placed in bit position 8.
The output SSM is placed in all bit positions.
<aid> =RTMg[-p]
Sets the Line Build-out length to 0 to 133 ft
Sets the Line Build-out length to 133 to 266 ft
Sets the Line Build-out length to 266 to 399 ft
Sets the Line Build-out length to 399 to 533 ft
Sets the Line Build-out length to 533 to 650 ft
Cut-thru mode is engaged when the Local Oscillator
enters Free-run mode.
Cut-thru mode is not engaged when the Local
Oscillator enters Free-run mode.
097-58001-01 Revision E – September 2006
Default
SQUELCH
ON
ENABLE
ALL
0
RETIME