Symmetricom TimeProvider 1100 Reference Manual page 32

Chapter 2 TL1 Command Syntax and Description
The Firmware Download Process
Response Example
TP-SSU 05-03-09 14:11:20
A 400 REPT EVT
"IMC,EQPT:FWLOAD,TC,05-03-09,14-11-20,,,,:\"BEGINNING FIRMWARE UPGRADE\""
;CCCCCCCCCCCCCIP TP1000
<
TP-SSU 05-03-09 14:19:59
TP1000
M COMPLD
;
TP-SSU 05-03-09 14:19:57
A 401 REPT EVT
"IMC,EQPT:FWOK,TC,05-03-09,14-19-57,,,,:\"FIRMWARE UPGRADE SUCCESSFUL\""
;
Example 3
In this example, the system has redundant IOCs (IOC1 and IOC2) and the
ACT-SWDL command is issued to download firmware to the modules (AID is IOC2).
IOC2 is active and IOC1 is in standby mode. After the file downloads, IOC1
becomes active and locked and IOC2 goes into standby to receive the firmware file.
The download and upgrade is successful for both modules:
Note: Some events in the following example were removed for space
considerations.
Input
ACT-SWDL::IOC:TP1000;
Response Example
TP-SSU 05-03-09 20:34:03
A 447 REPT EVT
"IOC,EQPT:FWLOAD,TC,05-03-09,20-34-03,,,,:\"BEGINNING FIRMWARE UPGRADE\""
;CCCIP 0
<
TP-SSU 05-03-09 20:36:06
A 448 REPT EVT
"IOC2,EQPT:IOCMODE,TC,05-03-09,20-36-06,,,,:\"IOC MODE IS, STANDBY\""
;
TP-SSU 05-03-09 20:36:07
A 449 REPT EVT
"IOC1,EQPT:IOCMODE,TC,05-03-09,20-36-07,,,,:\"IOC MODE IS, ACTIVE\""
;
TP-SSU 05-03-09 20:39:26
A 450 REPT EVT
"IOC2,EQPT:RESET,TC,05-03-09,20-39-26,,,,:\"MODULE HAS BEEN RESET\""
;
TP-SSU 05-03-09 21:02:45
A 461 REPT EVT
"IOC2,EQPT:CLKLOCK,TC,05-03-09,21-02-45,,,,:\"CLOCK ENTERED LOCK MODE\""
;
32 TimeProvider TL1 Reference Guide 097-58001-01 Revision E – September 2006