Chapter 5 Cli Commands; Overview; Timeprovider 100 Cli Command Conventions; Timeprovider 100 Cli Command Set - Symmetricom TimeProvider 100 User Manual

Chapter 5 CLI Commands

In This Chapter

Overview



TimeProvider 100 CLI Command Set


Command Groups

Show Commands

Set Commands

Overview
The Command Line Interface (CLI) is used to display information or configure and
manage the TimeProvider 100 from either a terminal connected to the EIA-232
serial port or the Ethernet port.
The section describes the CLI command conventions, CLI command keyboard
usage, and command-line form.
set show
snmp
configuration
eia232
user
users
snmp
alarmconfig
password
active_alarm
alarmconfig
ipconfig
ipconfig
gps
gps
clock
ip
log
output
output
clock
inventory
status
ipstatus
image
Figure 5-1.

TimeProvider 100 CLI Command Conventions

The following are conventions used for the TimeProvider 100 CLI command set.
[ ] – Brackets provide information about the allowed range. The first value is the

minimum, and the last value is the maximum.
{ } – Braces signify more than one parameter data option.

098-00106-000 Revision A – March, 2009
TimeProvider 100 CLI Command Set
ping reboot
TimeProvider 100 CLI Command Set
Figure 5-1 shows the general structure of the CLI.
upgrade switchfirmware
cli-settings
logout
TimeProvider 100 User's Guide 53