Symmetricom TimeProvider 1100 Reference Manual page 147

Table B-1. Alarms (Continued)
Alarm ID
Alarm Condition
or
Description
CONDTYPE
INPLOS The 1PPS from GPS is
LOS. The LOS must be
continuously present for
the Fault Delay Time
(FLTDELAY) before
disqualifying the input
as a possible reference.
After INPLOS is set, the
alarm clears when the
input signal is LOS free
for the Clear Delay Time
(CLRDELAY).
INPPHASE The specified input port
has a excessive phase
measurement that
disqualifies it from being
used.
EXDSC Input has had excessive
discontinuities. This is
indicated when there
are more than 3 signals
faults of the same type
within a 5-minute
window. The alarm
clears when the 5-
minute window contains
less than 3 alarms of the
same type.
FFOFF Input has exceeded the
Fractional Frequency
Offset threshold.
MTIE Input has exceeded at
least one of the MTIE
alarm thresholds.
TPIUSIG TimeProvider
Composite Timing
Signal interface is not
functioning
097-58001-01 Revision E – September 2006
Error
AID Service
Delay
Type Affecting
Default
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
T1 NSA IMMED
Appendix B Alarms
Alarm Default
Error
Level
Delay
Editable
SSU PRS SUB
NO MN MN
NO MN MN
NO MN MN
NO MN MN
NO MN MN
NO MN MN
TimeProvider TL1 Reference Guide 147
MN
MN
MN
MN
MN
MN