Symmetricom TimeProvider 1100 Reference Manual page 155

Table B-2. Alarm Code Condition Descriptions (Continued)
Alarm ID Set Alarm Condition Description
INPDISQ Input Disqualified as Possible Reference
INPAIS AIS Fault
INPLOS LOS Fault
INPOOF OOF Fault
INPFRQ Frequency Threshold Exceeded
INPPHASE Phase Error Exceeded Threshold
INPQL Quality Level (SSM) Exceeded Threshold
INPTRR Tip/Ring Connections Reversed
EXDSC Excessive Discontinuity Fault
MTIE MTIE Threshold Exceeded
FFOFF FFOFF Threshold Exceeded
E422EQPT EIA-422 Module is Unequipped
E422FAULT EIA-422 Module has a Fault
OUTEQPT Output Module is Unequipped
RTMEQPT Retimer Module is Unequipped
S1LOS Side 1 LOS Fault
S2LOS Side 2 LOS Fault
EXSLIP Slip Rate Threshold Exceeded
RTMFAULT Retimer Module has a Fault
097-58001-01 Revision E – September 2006
INP[p] Alarm Conditions
E422g Alarm Conditions
OUTg Alarm Conditions
RTMg[-p] Alarm Conditions
Clear Alarm Condition Description
Input Qualified as Possible Reference
AIS Fault Cleared
LOS Fault Cleared
OOF Fault Cleared
Frequency Within Threshold
Phase Error Within Threshold
Quality Level (SSM) Within Threshold
Tip/Ring Connections Correct
Excessive Discontinuity Cleared
MTIE Within Threshold
FFOFF Within Threshold
EIA-422 Module is Equipped
EIA-422 Module Fault Cleared
Output Module is Equipped
Retimer Module is Equipped
Side 1 LOS Fault Cleared
Side 2 LOS Fault Cleared
Slip Rate Within Threshold
Retimer Module Fault Cleared
TimeProvider TL1 Reference Guide 155
Appendix B Alarms