Symmetricom TimeProvider 1100 Reference Manual page 168

Appendix C Events
Table C-1. Event Identifiers (Continued)
Event ID
or Event Description
CONDTYPE
HOLDFLT Defines if the Retimer
mode operates or not
when the LO enters
Holdover mode of
operation. The output
groups are provisioned
for fault strategies.
RTMLBO The Line Buildout on the
specified Retimer port
has changed.
RTMSTATE The state of the specified
Retimer port has
changed.
SLIPCHG The Retimer slip
threshold has changed.
SLIPCLR The Retimer slip counter
has been cleared
Table C-2. Event Code Condition Descriptions
Event ID
ACCLVL USER ACCESS LEVEL HAS CHANGED
ACO AUDIO ALARM IS DEACTIVATED
ALMCHG ALARM PARAMETER HAS CHANGED, <keyword>,<alarm>
AOMERGE AUTONOMOUS EVENT REPORTING HAS CHANGED, <state>
BAUD SERIAL BAUDRATE HAS CHANGED, <value>
CMDCHG COMMAND ACCESS LEVEL HAS CHANGED, <command>
ECHO SERIAL PORT ECHO MODE HAS CHANGED, <state>
FEATURE SYSTEM FEATURE HAS BEEN ACTIVATED, <feature>
168 TimeProvider TL1 Reference Guide
AID
Default Value
TYPE
T1 CUTTHRU
T1 0
T1 ENABLE
T1 4
T1 NA
Event Condition Description
IMC Event Conditions
Value Description
RETIMER – In fault mode the
output signals are retimed
CUTTHRU – In fault mode the
cut-thru mode is enabled, and
output signals are not retimed.
0 = 0 to 133 ft
1 = 133 to 266 ft
2 = 266 to 399 ft
3 = 399 to 533 ft
4 = 533 to 650 ft
ENABLE – Enable the Retimer
port
DISABLE – Disable the
Retimer port and clear all
alarms associated with the
port.
1 to 255
NA
097-58001-01 Revision E – September 2006